SikaRep®-105

12 months minimum from production date.

The product must be stored in original, unopened and undamaged sealed packaging, in dry conditions at temperatures between 5 °C and 35 °C. Protect from direct sunlight.

2.0 – 2.1kg/litre

0,5 mm

~ 20 Mpa at 28d

For normal application add 5.0 – 5.5 litres of water per 25 kg of SikaRep®-105 depending on the desired consistency. Mixing can be achieved either manually or mechanically. Mechanical mixing is preferred for quantities greater than 1 bag.

5 mm to 30 mm

Minimum +5°C / Maximum +35°C.

Minimum +5°C / Maximum +35°C.

1h at 30°C

Wait about 1 week before covering with paint or Coating.

Mix 25 kg bag with the necessary, above mentioned, amount of cold water until a homogeneous consistency is achieved.

• For 5kg of mortar the mixing water is about 1 liter.
• If the substrate is smooth and non-porous, it is recommended to mix SikaRep®-105with a Sikalatex solution (1 volume Sikalatex for 3 volumes of water).
• After mixing and before application, let the mix stand for 5 minutes

• Pre-damp the repair substrate with clean water and apply the mortar by trowel or spatula
• Before hardening, smooth the surface with sponge or polystyrene trowel

Curing is important where ambient conditions may lead to rapid surface drying, the use of light water fogging for 48 hours or Sika®Antisol curing compounds are recommended. (Do not commence fogging until initial set has been reached; typically 1 - 2 hours depending upon ambient conditions.)

With water immediately after use